falcoron

anyone using EML 300b tubes?

Recommended Posts

Hmm, I should've noticed that, thanks Graham. So for certainty, is my amp safe for continued use of these tubes? As it happens I haven't been using them but it would be nice to be certain. I doubt there can be a problem with the AVVT32B a I have been using them for yonks - 1.3A, but now you've raised the issue is this ok? :nerves:

Share this post


Link to post
Share on other sites
Hmm, I should've noticed that, thanks Graham. So for certainty, is my amp safe for continued use of these tubes? As it happens I haven't been using them but it would be nice to be certain. I doubt there can be a problem with the AVVT32B a I have been using them for yonks - 1.3A, but now you've raised the issue is this ok? :nerves:

Apparently they have 2 versions,

"We have two versions for the heater: Normal heater, or Center Tapped heater."

Read here, they say these can be used as a direct replacement but then go on to state the higher ratings?

http://www.emissionlabs.com/datasheets/EML300B-XLS.htm

Share this post


Link to post
Share on other sites

The Centre Tapped Heater version can only be used with a Octal base so it is not UX4 compatible.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Recently Browsing   0 members

    No registered users viewing this page.