ChemMan

Tube rolling with 12AT7 and 12AX7A on MA252 preamp

Recommended Posts

6 minutes ago, Tune said:

IMHO the best solution is to try to "audition" as many options as possible - and to move on the lesser models ASAP for a very slight loss. That way YOU know in YOUR system.

That's pretty much my plan.  I've ear-marked 400 euro for tubes and have spent 150 so far.

  • Like 1

Share this post


Link to post
Share on other sites
Posted (edited)
5 minutes ago, ChemMan said:

Any recommendations as far as suppliers go?

I can only  comment for the UK ...but Watford Valves take some beating.

Edited by Smokestack

Share this post


Link to post
Share on other sites

I finally got my replacement Tesla ECC 803s.  It's hard to say, but it feels like their is a bit more punch, rumble and liveliness with the NOS tubes.  I switched back and forth a couple time just to make sure the gain was the same. (there was a 1% difference on the MA252's volume meter between the two set of tubes)

Certainly not scientific testing and I'm sure it falls within the regions of expectation bias, but A/B is hard when you have to switch between tubes.

To sum up, it sounds a bit like swapping in a new DAC.

Share this post


Link to post
Share on other sites
On ‎23‎/‎05‎/‎2019 at 11:09, Smokestack said:

I can only  comment for the UK ...but Watford Valves take some beating.

I've also had some good valves from Langrex.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Recently Browsing   0 members

    No registered users viewing this page.