Guest

Hypex modules

4 posts in this topic

Thinking of dusting my soldering off again.

Anyone have any experience with these? I have read about these a fair bit online, but was after some wam experience too.

I was thinking of the 180watt UcD180HG with HxR, which should be plenty of grunt for my Tannoys. Still not decided between using a transformer and one of their regulated supplies or using the switch mode power suppply.

0

Share this post


Link to post
Share on other sites

hallo mate, give HoopsOnToast a pm he was talking about them some time ago.

0

Share this post


Link to post
Share on other sites

I would recommend EcoTeC amplifier modules. Made in the UK and can be seen here : http://www.amplifier.co.uk/index.htm

Not a big fan of switch mode PS usually end up with RFI problems

0

Share this post


Link to post
Share on other sites
Moderator

Hi, I looked into it a while back, they are very simple to do (from what i have read) as its really just plug and play. There are a lot of projects on the tinterweb using these modules. As well as a few commercial amplifiers that have them.

The UCD-180 module is only 90WPC into 8 Ohms, something like the UCD-400 module (200WPC into 8 Ohms) might be a better bet, just for fun!

They do have plate amps with DSP / Crossovers built in so you could go active at the same time -

http://www.europe-audio.com/Product.asp?Product_ID=7737

http://www.europe-audio.com/Product.asp?Product_ID=8144

Which is something i have also looked into :)

0

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now

  • Recently Browsing   0 members

    No registered users viewing this page.